Follow the steps in this article to set up your new Wyze Cam Floodlight v2. ⚡️
Before you begin setup, use our Wyze Cam Floodlight v2 Installation Guide to install the floodlight.
To set up your Wyze Cam Floodlight v2:
-
After completing the installation process in the Wyze app, tap Begin Setup.
- Floodlight not installed, with power? Follow the steps listed in our Wyze Cam Floodlight v2 Installation Guide before beginning setup.
-
The status light should begin flashing red.
- If the light is flashing red, check the box next to Light is flashing red, then tap Next.
- If the light does not turn on, press and hold the SETUP button on the side of the camera to reboot the camera.
-
Wait for the voice prompt to say "ready to connect."
- After the prompt, check the box next to It said, "Ready to connect", then tap Next.
- If there is no voice prompt, press and hold the SETUP button for 10 seconds to reboot the camera, then try again.
- Give location permissions for the floodlight's Dusk to Dawn setting. Tap Next.
- Your floodlight will pair to the Wyze app - stay nearby.
-
Select your 2.4 GHz Wi-Fi network and enter your network password. Tap Next.
- Tap the icon in the password field to display the password to ensure it was entered correctly.
-
Your floodlight will connect to your Wi-Fi network.
- If connection fails, wait for the voice prompt and try again.
- Name your Wyze Cam Floodlight v2 using the text field, or by choosing a suggestion. Tap Finish when done.
- You may have a prompt for a free trial of Cam Plus. Tap Continue.
- Set up some automations on the Things to Try* page, or tap Skip.
- You are all set! Your floodlight is set up and ready to go. Tap Done.
Things to Try: Tap Add your device to a group, Share this device, Automate your device, or Skip. These are quick ways to set up a few automations before you finish setup. When you complete a task, it'll display a green checkmark ✅. You can move on from this page by tapping Skip.