My Wyze Thermostat screen is stuck on the Wyze logo.

Presents as: You have installed your Wyze Thermostat, but the screen is stuck on the Wyze logo.

Troubleshooting: 

1. If you are using the c-wire adapter, please ensure that all the wires are connected to the correct terminal.
• Make sure there is just one wire per terminal. 
2. Perform a factory reset, and then try again.
• To factory reset, press and hold the control wheel for 10 seconds.
3. Remove and rewire your Wyze thermostat.
• Wait at least 30 seconds before rewiring after you remove the wiring.