Articles in this section

Wyze Lock Calibration Guide

During setup, Wyze Lock calibrates to recognize when your door is open, ajar, or closed. This works by using a sensor in the lock to determine its position relative to its closed state. Outside of the setup process though, calibrating the lock can help if Auto-Lock or the Ajar Alarm aren’t working properly.

Before calibrating:

  • Enable Bluetooth on your mobile device.
  • Stand near the lock for the duration of the calibration.
  • Skip to step 5 if you just completed the Wyze Lock Setup process.

To calibrate your Wyze Lock:

  1. Open the Wyze app and tap Wyze Lock.
  2. Tap the gear SettingsGear.png icon to open Lock Settings.
  3. Scroll to the bottom of settings screen and tap Calibrate.
  4. Close your door and manually lock the deadbolt.
  5. Tap Next, and wait for your Wyze Lock to chime.
  6. Manually unlock the deadbolt and open the door as wide as possible.
  7. Tap Next and wait for your Wyze Lock to chime.
  8. Partially close the door so it's slightly ajar, with a small gap between the door and the frame.
  9. Tap Next and wait for your Wyze Lock to chime.
  10. Finally, close the door again and manually lock the deadbolt.
  11. Tap Next to complete the calibration. Wyze Lock will then unlock and lock itself twice in succession to make sure the deadbolt functions properly.
Was this article helpful?
50 out of 90 found this helpful